Vicor Full-chip PRM-RS Customer Board - Manual (Page 13)

UG:009 vicorpower.com Applications Engineering: 800 927.9474 Page 13
9. Insert oscilloscope probe into VTM ® Board output probe jack.
10. Connect DMM to the VTM board output test points and to any other signals to be measured.
11. Set PC Enable Switch (S0_2) to the left position.
12. Apply nominal input voltage.
13. Measure VTM module output voltage and verify operation.
14. Use the output voltage trim pot (R 22 ) to adjust the output to the desired level.
a. Do not trim below the minimum input voltage of the VTM module used.
15. Apply 100% load, and verify full load operation.
16. Turn off load and power. Proceed to following sections for detailed test procedure.
Figure 11: Full-chip PRM-RS
Customer Board connection to
VTM Customer Board Type A
Figure 12: Full-chip PRM-RS
Customer Board Connection to
VTM Customer Board Type B