Waters End Connector Kit - Manual

[ Care and Use ManUal ]
I. IntroductIon
The End Connector Kit, part number WAT037525, can be used with
any Waters 3.9 mm or 4.6 mm i.d. cartridge. The cartridge and the
End Connector Kit are purchased separately. When the performance
of the cartridge deteriorates, you just replace the cartridge and reuse
the endfittings.
The End Connector Kit contains the following parts:
description Quantity
Endfitting assemblies 2
Retaining nuts 2
C-Clips 2
II. SpecIfIcatIonS
Maximum pressure rating: 40 Mpa (400 atm, 6000 psi).
III. aSSemblIng the cart rIdge
1. Remove the plastic end caps from the cartridge and save for
cartridge storage.
2. Slide a retaining nut onto the cartridge with the open end of the
nut toward the end of the cartridge.
3. Press a c-clip into the groove of the cartridge until it snaps into
place.
4. Place the endfitting onto the cartridge and screw together the
retaining nut and endfitting until hand-tight. If the threads on
the endfitting visible, the retaining nut and endfitting are not
assembled properly. Unscrew and reassemble.
5. Repeat steps 2 through 4 to assemble the other end.
contentS
I. IntroductIon
II. SpecIfIcatIonS
III. aSSemblIng the cartrIdge
IV. uSIng the cartrIdge
V. replacIng the cartrIdge
VI. replacIng the o-rIngS In the endfIttIngS
VII. troubleShootIng
VIII. orderIng InformatIon
WaterS end connector KIt
Use this document in conjunction with the Waters Analytical Columns and Cartridges Care and Use Instructions
included with the Waters cartridge column.