Weidmuller WI-I/O 9-L: Wireless I/O Transmitter / Receiver v1.3 - Manual (Page 43)

WI-I/O 9-L Configuration Manual
WI-I/O 9-L Wireless I/O page 43 of 108
WI Series lets you:
If you want to … Description For more information, see
…
Create new units Lets you add new units by creating a new unit,
copying an existing unit.
Creating new units on page
44.
Delete units Lets you remove a unit from the system. Deleting units on page 60.
Setting unit
information
Lets you set mandatory information for all units in a
system regardless of the type of unit:
Setting unit information on
page 52.
Load unit addresses Lets you set the unit address that determines how
the network communicates with the module.
Setting the unit address on
page 54.
Load protocol types Protocol type is always disabled for the WI-I/O 9-L.
Note : Only the WI-GTWY modules support protocol
types.
Set unit mappings Mappings let you configure messages to be sent
from one module to another.
Sending data to another
station using mappings on
page 62.
Set unit output reset
times
You can configure outputs to turn off (i.e. reset) if
the output is not sent data for a long time. Output
reset time is the time to wait after receiving data
before resetting the output to a safe state (0mA for
analog, off for digital).
Handling communication
failures by setting output
reset times on page 86.
Set unit sensitivities Unit sensitivities indicate the change required in an
analogue input for the module to detect a state
change and transmit a new value.
Setting unit sensitivities on
page 70.
Set unit pulsed inputs Pulsed inputs count the number of pulses. Counting events by setting
unit pulsed inputs on page
71.
Set unit setpoints Lets you generate a digital on/off value from the
value of an analog input.
Setting setpoints on page
73.
Set unit debounce Lets you set the time an input must differ from its
previous value before the module identifies a state
change.
Setting additional unit detail
information on page 81.
Show unit summary Lets you view and print the user options configured
for the unit.
Showing and printing the
unit summary on page 58.
Show mapping
summary
Lets you view and print the mappings for the unit. Showing and printing the
unit mappings on page 59.
For more information, see the next sections.