Rockwell Automation 20P PowerFlex DC Drive - Frame D AC Current Transducers - Manual

Publication 20P-IN059A-EN-P
PowerFlex® DC Drive
Frame D AC Current Transducers
Installation Instructions
What This Kit Includes • Two AC current transducers
• Four mounting screws
• Static strap
Tools That You Need • Hexalobular screwdriver
• Flathead screwdriver
• Torque wrench
What You Need to Do To install the AC current transducers:
❐ Step 1: Remove power from the drive
❐ Step 2: Remove the protective covers and open the control panel
❐ Step 3: Remove the existing AC current transducers
❐ Step 4: Install the new AC current transducers
❐ Step 5: Close the control panel, replace the covers and document the
change
ATTENTION: Only qualified personnel familiar with DC drives
and associated machinery should plan or implement the installation,
start-up and subsequent maintenance of the system. Failure to comply
may result in personal injury and/or equipment damage.
ATTENTION: To avoid an electric shock hazard, ensure that all
power to the drive has been removed before performing the following.
ATTENTION: This drive contains ESD (Electrostatic Discharge)
sensitive parts and assemblies. Static control precautions are required
when installing, testing, servicing or repairing this assembly.
Component damage may result if ESD control procedures are not
followed. If you are not familiar with static control procedures,
reference A-B publication 8000-4.5.2, “Guarding Against
Electrostatic Damage” or any other applicable ESD protection
handbook.