Rockwell Automation 20P PowerFlex DC Drive - Frame D AC Current Transducers - Manual (Page 5)

5
Publication 20P-IN059A-EN-P
3. Remove the bolt and washer that secures each of the U and W phase AC
input terminal bus bars to the rear insulator bar.
4. Remove the two nuts and washers that secure the signal wires to the
terminals on each of the AC current transducers and remove the wires.
5. Loosen the two screws that secure each of the AC current transducers to the
U and W phase terminal bus bar. The current transducers will be loose on
the bus bars.
XF XC
Remove bolt
and washer
Loosen two
screws on CTs Remove nut, washer
and, signal wires