Rockwell Automation 20P PowerFlex DC Drive - Frame D AC Current Transducers - Manual (Page 3)

3
Publication 20P-IN059A-EN-P
2. Loosen, but do not remove, the six hexalobular screws that secure the top air
flow plate to the drive, then slide the plate forward to lift it off the screws.
Tightening torque is noted in the illustration for reassembly.
Note: The air flow plate cannot be removed from the drive unless the AC
input wiring and bus bar extensions (if installed) are removed. However, the
plate must be removed to remove the AC input terminals below it.
3. Disconnect the DPI cable from the HIM (if present).
4. Insert a flathead screwdriver into the holes in the right side of the protective
covers on the drive, turn the latch 90° counter-clockwise, and open the
control panel to the left.
Tightening torque:
1.5 N•m (13 lb•in)
T15
Loosen
screws Loosen
screws
Pull plate forward to lift off screws
Top View of Drive
90°
Disconnect DPI cable