Rockwell Automation 20D-DL2-ENETO DriveLogix 5730 Controller Embedded EtherNet/IP Option Card - Manual (Page 4)

4 Embedded EtherNet/IP Option Card for DriveLogix™5730 Controllers
Step 2: Opening Door Over
Power Structure and Main
Control Board
Step 3: Removing the
Control Cassette from Drive
Frames 1-4
Locate the slot in the upper left corner. Slide
the locking tab up and swing the cover open.
Special hinges allow cover to move away from
drive and lay on top of adjacent drive (if
present).
Frame 5
Slide the locking tab up, loosen the right-hand
cover screw and remove.
Frame 6
Loosen 2 screws at bottom of drive cover.
Carefully slide bottom cover down & out.
Loosen the 2 screws at top of cover and
remove.
BR1 BR2 DC+ DC- PE
U/T1 V/T2 W/T3 R/L1 L2
Task Description
Disconnect the cables that connect to the main board
Loosen screws on face of cassette
Remove the cassette
A
B
C
Proper tightening torque for
reassembly is 7 to 10 lb.-in.
=
A
C
B
B