Rockwell Automation 20D-DL2-ENETO DriveLogix 5730 Controller Embedded EtherNet/IP Option Card - Manual (Page 5)

Embedded EtherNet/IP Option Card for DriveLogix™5730 Controllers 5
Step 4: Removing the Inside
Cover from the Control
Cassette
Step 5: Removing the
Embedded EtherNet/IP
Option Board
Proper tightening torque for
reassembly is 7 to 10 lb.-in.
Task Description
Loosen screws on face of front cover and remove
the cover
A
=
A
A
A
A
A
B
C
C
Task Description
Remove screws
Remove Embedded EtherNet/IP Option Board from
the Main Control Board
Remove standoffs
Do not perform this task if you are installing a new
Embedded EtherNet/IP Option Board
A
B
C C
=