Rockwell Automation 20D-DL2-ENETO DriveLogix 5730 Controller Embedded EtherNet/IP Option Card - Manual (Page 6)

6 Embedded EtherNet/IP Option Card for DriveLogix™5730 Controllers
Step 6: Installing the
Embedded EtherNet/IP
Option Board
Step 7: Replacing the
Covers and Control
Cassette The procedure for replacing the covers and control cassette is the reverse of
removing these components. Refer to
Step 4: Removing the Inside Cover
from the Control Cassette on page 5 , Step 3: Removing the Control Cassette
from Drive on page 4 and Step 2: Opening Door Over Power Structure and
Main Control Board on page 4 .
Step 8: Configuring
EtherNet/IP Communication Referring to publication 20D-UM003
… , User Manual - DriveLogix5730
Controller, configure the EtherNet/IP port on the option card.
A
A
B
C
D
D
Task Description
Install and tighten standoffs (7 to 10 lb.-in.)
Align connector on Embedded EtherNet/IP Option
Board with connector on Main Control Board
Place Embedded EtherNet/IP Option Board on the
Main Control Board
Install and tighten screws (7 to 10 lb.-in.)
A
B
C C
D
=