Rockwell Automation 22-COMM-P PowerFlex Profibus Adapter - Manual (Page 66)

7-6 Using Multi-Drive Mode
Figure 7.7 and Figure 7.8 show wiring diagrams for using
AK-U0-RJ45-TB2P terminal block connectors and terminating resistors.
Figure 7.7 Connector Wiring Diagram - With Adapter in Drive
Figure 7.8 Connector Wiring Diagram - With Adapter in DSI External Comms Kit
NOTE: When connecting the drives in a Multi-Drive configuration, the
order in which the drives are connected does not matter. That is, Drive 0
can be any of the drives, and Drive 0 does not have to be the drive in
which the adapter is installed (or the drive to which the DSI External
Comms Kit is plugged into).
To Drive 0
(PowerFlex 40/40P/400 drive with
installed 22-COMM-P adapter)
120 Ohm,
¼ Watt
Terminating
Resistor
To
Drive 1
To
Drive 2
To
Drive 3
To
Drive 4
120 Ohm,
¼ Watt
Terminating
Resistor
To DSI External Comms Kit
(with installed 22-COMM-P adapter)
NOTE: A terminating resistor is not
required for this end of the wiring.
The resistor is built into the circuitry
of the DSI External Comms Kit.
To
Drive 1
To
Drive 2
To
Drive 3
To
Drive 4
120 Ohm,
¼ Watt
Terminating
Resistor
To
Drive 0