Rockwell Automation 20B PowerFlex 700 Drives - Frame 10 Components Replacement - Manual (Page 47)

Rockwell Automation Publication 20B-IN026B-EN-P - July 2013 47
Inverter Assembly Component Replacement Procedures Chapter 3
Switch Mode Power Supply
Board See Chapter 1 - Component Diagrams and Torque Specifications to locate
components in these instructions.
Remove Components
1. Read and follow the
Safety Precautions on page 11 and Important Initial
Steps on page 12 .
2. Remove safety shields and enclosure covers as needed.
3. Remove the Main Control Panel. See
Main Control Panel (Inverter
Assembly) on page 22 .
4. Carefully label and disconnect all wiring from the Switch Mode Power
Supply Board.
5. Remove the Switch Mode Power Supply Board mounting torx screw
located at the lower right corner of the board.
Connector Wire Color(s) Connects To:
J1 Black J2 on Power Interface Board
J2 Black J13 on Power Interface Board
J3 Red/White J12 on Power Interface Board
J4 Open
Torx Screw Spacers (3)
J2 J4 J3 J1