Install components – Rockwell Automation 20B PowerFlex 700 Drives - Frame 10 Components Replacement User Manual
Page 57
Rockwell Automation Publication 20B-IN026B-EN-P - July 2013
57
Inverter Assembly Component Replacement Procedures
Chapter 3
Install Components
1. Carefully examine the Transitional Busbar Assembly and Bus Capacitors
for damage.
When replacing any IGBT module, we recommend that you replace all
Bus Capacitors. If needed, see
to replace
damaged Bus Capacitors.
2. Install the IGBT module.
a. Use isopropyl alcohol to thoroughly clean the surface of the Heatsink.
b. Verify that the mounting surface of the new IGBT module is clean. If
not, clean the mounting surface with isopropyl alcohol.
c. Use a 3- or 4-inch paint roller or putty knife to apply a thin even coating
of the supplied thermal grease to the mounting surface of the IGBT
module.
In the next step, take care to not disturb any of the thermal grease on the
IGBT module.
d. Place the IGBT on the chassis with the serial number label at the top.
Install with supplied screws using this torque sequence:
IMPORTANT
If the Transitional Busbar Assembly was not removed, take care to not
damage the Flexible Capacitor Busbars fitting over and under the
Transitional Busbar Assembly.
➑
➋
➍
➏
➎
➌
➊
➐
IGBT Torque Sequence
First Sequence: 0.7 N•m (6.0 lb•in)
Second Sequence: 1.5 N•m (14 lb•in)
Final Sequence: 5.6 N•m (50 lb•in)
IMPORTANT
The three positive (+) Flexible Capacitor Busbars supplied with the kit must
be installed on the back side of the Transitional Busbar Assembly before
they can be installed on the IGBT. See page
for how to install these
busbars on the Transitional Busbar Assembly.