Rockwell Automation 20P PowerFlex DC Drive - Frame C Pulse Transformer Circuit Board - Manual

Publication 20P-IN010C-EN-P - February
Installation Instructions
PowerFlex DC Drive Frame C Pulse Transformer Circuit Board
What This Kit IncludeS
• Pulse Transformer circuit board
• Six screws and washers
• 6 gate lead cables with connectors (for non-regenerative drives only)
• 12 gate lead cables with connectors (for regenerative drives only)
• Cables for connectors XR and XSW
• Static strap
Tools That You Need • Phillips ®
screwdriver
• Flathead screwdriver
Phillips
®
is a registered trademark of Phillips Screw Company.
ATTENTION: Only qualified personnel familiar with DC drives and associated
machinery should plan or implement the installation, start-up and subsequent
maintenance of the system. Failure to comply may result in personal injury and/
or equipment damage.
ATTENTION: To avoid an electric shock hazard, ensure that all power to the drive
has been removed before performing the following.
ATTENTION: This drive contains ESD (Electrostatic Discharge) sensitive parts
and assemblies. Static control precautions are required when installing, testing,
servicing or repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with static control
procedures, reference A-B publication 8000-4.5.2, “Guarding Against
Electrostatic Damage” or any other applicable ESD protection handbook.