Rockwell Automation 284E ArmorStart EtherNet IP Communications and Control Programming Manual - Manual (Page 50)

50 Rockwell Automation Publication 280E-PM001A-EN-P – August 2011
Chapter 5 ArmorStart ® EtherNet/IP ™ Communications & Control Programming Manual
iii. The output of Rung 0 is now set to be the RunForward command
that causes the load to run in the forward direction. The ladder logic
element should look like the figure below.
c. Select the JogForward tag for the output ladder element for Rung 2.
i. Double click on the question mark over the output ladder element
on Rung 2 and click on the drop-down arrow to show the available
tag options for this element.
ii. Expand the options for the AS_EIP_284:O by clicking on the plus
next to AS_EIP_284:O. Select AS_EIP_284:O.JogForward tag
name and hit Enter.