Rockwell Automation 284E ArmorStart EtherNet IP Communications and Control Programming Manual - Manual (Page 9)

Rockwell Automation Publication 280E-PM001A-EN-P – August 2011 9
ArmorStart ® EtherNet/IP ™ Communications & Control Programming Manual Chapter 1
5. Select the ArmorStart in your application and click OK.
6. The AOP is shown below. Enter a Name for this ArmorStart and an
Ethernet address. For this example, the Private Network setting will be
used. This should be set to match the IP address switch setting on the
ArmorStart. Then press OK.
Note: Refer to Using the Rotary Network Address Switches in
Appendix B to set an IP address on the device.