Rockwell Automation 284E ArmorStart EtherNet IP Communications and Control Programming Manual - Manual (Page 7)

Rockwell Automation Publication 280E-PM001A-EN-P – August 2011 7
Chapter
1
Adding an ArmorStart to RSLogix 5000
This section will show you how to add an ArmorStart Add-On-Profile (AOP) to
RSLogix 5000. It is assumed that you have downloaded and installed the AOP so
that the RSLogix 5000 software can fully support the ArmorStart Ethernet/IP.
The AOP can be downloaded from:
http://support.rockwellautomation.com/
controlflash/LogixProfiler.asp .
1. Open RSLogix 5000 by double-clicking on the icon on your desktop.
2. Select File>New to create a new project.