Rockwell Automation 284E ArmorStart EtherNet IP Communications and Control Programming Manual - Manual (Page 8)

8 Rockwell Automation Publication 280E-PM001A-EN-P – August 2011
Chapter 1 ArmorStart ® EtherNet/IP ™ Communications & Control Programming Manual
3. Enter the name of the project and select your controller from the Type
drop down menu. For this example, a Cat. No. 1769-L35E and software
revision 19 will be used. Then click OK.
4. To add a new module to the tree, right-click on Ethernet and select
New Module. This allows you to add a new ArmorStart to the Logix
Project.