Rockwell Automation 20-750-DNET PowerFlex DeviceNet Option Module - Manual (Page 17)

Rockwell Automation Publication 750COM-UM002B-EN-P - October 2012 17
Chapter
2
Installing the Option Module
This chapter provides instructions for installing the option module in a
PowerFlex 750-Series drive.
Preparing for an Installation Before installing the option module, do the following:
• Read the DeviceNet Media Design and Installation Guide, publication
DNET-UM072
• Read the DeviceNet Starter Kit User Manual, publication DNET-
UM003 .
• Verify that you have all required equipment. See Required Equipment on
page 13 .
Topic Page
Preparing for an Installation 17
Setting the Node Address Switches 18
Setting the Data Rate Switch 19
Connecting the Option Module to the Drive 19
Connecting the Option Module to the Network 20
Applying Power 21
Commissioning the Option Module 24
ATTENTION: Risk of equipment damage exists. The option module contains
electrostatic discharge (ESD) sensitive parts that can be damaged if you do not
follow ESD control procedures. Static control precautions are required when
handling the option module. If you are unfamiliar with static control procedures,
see Guarding Against Electrostatic Damage, publication
8000-4.5.2 .