Connecting the communication cable to the module – Rockwell Automation 160IB1 InterBus Communication Module User Manual
Page 17
Advertising
Installation and Wiring
3–7
Connecting the Communication
Cable to the Module
Follow these steps to connect your module.
1.
Verify that the cable/connector is correctly wired
(See Figure 3.6).
2.
Locate the D-shell (IN) connector at the base of the IB1 Module.
3.
Plug cable/connector into the IB1 D-shell connector and secure.
4.
Extend the network via the D-shell
(NEXT)
connector on the front.
5.
Last IB1 of network, D-shell (NEXT) connector must be left
empty for the network to be correctly terminated.
Figure 3.7
Remote Bus Connection
M a s t e r I n t e r f a c e s :
InterBus
Master
PLC
Remote Bus
InterBus
SSC160-C
InterBus
SSC160-C
InterBus
SSC160-C
m
f: female connector
m: male connector
m
m
f
f
f
Advertising