Rockwell Automation 1302 575v AC Drive - Canada Only - Manual (Page 5)

Chapter
1
1–1
Publication 1302-5.0 — January, 1998
Introduction
The purpose of this manual is to provide you with the necessary
information to install, program, start up and maintain the 1302 AC
Drive. This manual should be read in its entirety before operating,
servicing or initializing the 1302 Drive.
This manual is intended for qualified electrical personnel responsible
for installing, programming, starting up, and maintaining the 1302
drive.
This manual describes how to install and troubleshoot the 1302 AC
drive. Drive installation consists of the following basic tasks:
•
Plan your installation using the guidelines presented in chapter 3.
If your installation must be in compliance with Electromagnetic
Compatibility Standards, read Appendix E also.
•
Mount the Drive and install external components according to
the guidelines presented in chapter 4.
•
Wire the Drive’s input power, output power, and control signal
terminal strip using the instructions in chapter 5.
•
Adjust parameter values, if required. The parameters are
described in chapter 8. For quick reference, the factory-set
values are listed in Appendix B.
•
Perform the power-off and power-on checks described in chapter
6 to complete the installation.
If problems occur during Drive operation, refer to chapter 9.
Appendix F lists the parts of the Drive that can be replaced. Before
you begin the installation procedure, become familiar with the Drive
by reading chapter 2, which provides an overview of the Drive and
its features, chapter 7, which describes the operation of the keypad
and the display, and Appendix A, which lists the Drive’s technical
specifications.
Manual Objectives