Rockwell Automation 1500 DeviceNet MV Controllers Installation Instructions - Manual (Page 12)

3-4 DeviceNet Cable System Layout for Medium Voltage Controller Structures
1500-IN057C-EN-P – June 2013
LV
LV
MV
MV
When the leftmost section is
one end of trunk line, install
the terminating resister in the
leftmost connector. This end
requires a female connector. When the rightmost section is
one end of trunk line, install
the terminating resister in the
rightmost chetmag.
This end requires a male
connector.
LV
LV
MV
MV
When the leftmost section is
one end of trunk line, install
the terminating resister in the
leftmost connector. This end
requires a female connector. When the rightmost section is
one end of trunk line, install
the terminating resister in the
rightmost chetmag.
This end requires a male
connector.
Figure 3.4 – Typical Termination Resistor Locations
The above diagram illustrates the common equipment configuration and
the correct placement of the terminating resistors. The number of and
type of sections shown is arbitrary and for illustration purposes only.
Drawings are not to scale.