Rockwell Automation 1606-XLSRED40 Power Supply Reference Manual User Manual

Bulletin 1606 switched mode power supplies, Reference manual, Terminology and abbreviations

Advertising
background image

Reference Manual

e

g

a

P

e

g

a

P

1.

Intended Use .......................................................3

2.

Installation Requirements...................................3

3.

Input and Output Characteristics .......................4

4.

Power Losses........................................................5

5.

Lifetime Expectancy and MTBF...........................6

6.

Terminals and Wiring..........................................7

7.

Functional Diagram.............................................8

8.

Front Side and User Elements.............................8

9.

EMC ......................................................................9

10. Environment ......................................................10
11. Protection Features ...........................................11
12. Safety Features ..................................................11
13. Dielectric Strength ............................................11

14. Certifications .................................................... 12
15. Physical Dimensions and Weight ..................... 13
16. Accessories ........................................................ 14
17. Application Notes ............................................. 15

17.1. Recommendations for Redundancy.........15
17.2. Inductive and Capacitive Loads................15
17.3. Lateral Installation Clearances

............15

17.4. 1+1 Redundancy up to 20A......................16
17.5. N+1 Redundancy, Example with 60A ......16
17.6. Mounting Orientations ............................17

Bulletin 1606 Switched Mode Power Supplies

Catalog Number: 1606-XLSRED40

Index

•

PE and

symbol—PE is the abbreviation for Protective Earth and has the same meaning as the symbol

.

•

Earth, Ground—This document uses the term “earth” which is the same as the U.S. term “ground”.

•

T.b.d.—To be defined, value or description will follow later.

•

DC 24V—A figure displayed with the AC or DC before the value represents a nominal voltage with standard tolerances (usually ±15%) included. E.g.: DC
12V describes a 12V battery whether it is full (13.7V) or flat (10V)

•

24Vdc—A figure with the unit (Vdc) at the end is a momentary figure with no additional tolerance included.

•

may, shall, should—Three key words indicating, respectively: flexibility of choice with no implied preference, a mandatory requirement, flexibility of
choice

•

1+1 Redundancy—Use of two identical power supplies in parallel to provide
continued operation following most failures in a single power supply. The two
power supply outputs should be isolated from each other by using diodes or
other switching arrangements. E.g. two 10A power supplies are needed to
achieve a 10A redundant system.

•

N+1 Redundancy—Use of three or more identical power supplies in parallel
to provide continued operation following most failures in a single power supply.
All power supply outputs should be isolated from each other by using diodes or
other switching arrangements. E.g. to achieve a 40A redundant system, five 10A
power supplies are required in a N+1 redundant system.

Terminology and Abbreviations

N+1

Redundancy

1+1

Redundancy

AC

DC

AC

DC

AC

DC

AC

DC

AC

DC

AC

DC

IN 1

OUT

IN 2

IN 1

OUT

IN 2

IN 1

OUT

IN 2

Load

+

-

AC

DC

AC

DC

Load

+

-

IN 1

OUT

IN 2

Advertising
Table of contents