Cabinet preparation, Plenum placement on structure, Cabinet preparation plenum placement on structure – Rockwell Automation 1512A MV Controllers, 400A One-High Cabinet, Standard and Arc-Resistant Enclosure User Manual
Page 84
76
Rockwell Automation Publication 1512A-UM100F-EN-P - May 2013
Appendix B
ArcShield Plenum Installation Instructions
Cabinet Preparation
In preparation for mounting Plenum, remove 1/4-20 fasteners from the Relief
vent on the top of the MV enclosure. .
The Plenums are designed to fit over the fastener heads at the four corners of the
Relief vent. The corner fasteners are required to secure the Relief vent during
installation.
Plenum Placement on Structure
Once the Plenum has been lifted in place directly over the relief vent (shown in
), all 1/4-20 fasteners, removed in
above, are
replaced to attach the Plenum to the top of the enclosure. Use hand tools only.
IMPORTANT
Do not remove the four corner fasteners (
)
Figure 73 - Typical Relief Vent Fasteners (top view)
Figure 74 - Relief Vent
Relief vent
Relief fasteners
Corner fasteners