Rockwell Automation Logix5000 Program Parameters Programming Manual - Manual (Page 17)

Connecting program parameters Chapter 1
Connect an Output parameter to a controller scope tag
The following procedure explains how to connect an Output parameter to a
controller scope tag.
Tip: This procedure demonstrates the use of the Parameters tab on the Program Properties dialog box. You can
alternatively connect parameters using any of the other methods shown in Program parameter connection
methods on page 8 .
1. In the Controller Organizer, double-click the folder for the program for
which you are creating an Output parameter connection.
2. On the Program Properties dialog box, click the Parameters tab.
3. In the Name box, click the name of the Output parameter for which you
want to add a connection.
4. In the Connections area, click New Connection.
Rockwell Automation Publication 1756-PM021A-EN-P - October 2014 17