Rockwell Automation Logix5000 Program Parameters Programming Manual - Manual (Page 18)

Chapter 1 Connecting program parameters
5. In the New Connection box, type the tag to which you want to connect
this Output parameter, and click Apply.
6. Click OK to close the Program Properties dialog box.
Connect an Output parameter to another program
The following procedure explains how to connect an Output parameter to
another program.
Tip: This procedure demonstrates the use of the Properties pane on the Program Parameters and Local Tags
dialog box. You can alternatively connect parameters using any of the other methods shown in
Program
parameter connection methods on page 8 .
1. In the Controller Organizer, expand the folder for the program for which
you are creating an Output parameter connection, and double-click
Parameters and Local Tags.
2. On the Program Parameters and Local Tags dialog box, choose the
Output parameter that you want to connect.
18 Rockwell Automation Publication 1756-PM021A-EN-P - October 2014