Rockwell Automation Logix5000 Program Parameters Programming Manual - Manual (Page 22)

Chapter 1 Connecting program parameters
Connect an InOut parameter to a controller scope tag
The following procedure explains how to connect an InOut parameter to a
controller scope tag.
Tip: This procedure demonstrates the use of the Properties pane on the Program Parameters and Local Tags
dialog box. You can alternatively connect parameters using any of the other methods shown in Program
parameter connection methods on page 8 .
1. In the Controller Organizer, expand the folder for the program for which
you are creating an InOut parameter connection, and double-click
Parameters and Local Tags.
2. On the Program Parameters and Local Tags dialog box, choose the InOut
parameter that you want to connect.
3. On the right, in the Properties pane, expand Parameter Connections, and
click New Connection.
4. Click the Browse (...) button.
22 Rockwell Automation Publication 1756-PM021A-EN-P - October 2014