Rockwell Automation 1746-Px SLC 500 Power Supplies Installation Instructions - Manual (Page 15)

Installation Instructions 15
Publication 1746-IN004B-EN-P - March 2008
Certification
(when product is
marked) UL Listed Industrial Control Equipment for Class 1, Division 2,
Groups A, B, C, D Hazardous Locations UL Listed Industrial
Control Equipment
C-UL Listed Industrial Control Equipment for Class 1, Division 2,
Groups A, B, C, D Hazardous Locations CSA Certified
Process Control
Equipment for
Class 1, Div 2,
Groups A, B, C, D
Hazardous Locations
CE
(10)
European Union 89/336/EEC EMC Directive, compliant with:
EN 50082-2 Industrial Immunity
EN50081-2 Industrial Emissions
European Union 73/23/EEC LVD Directive, compliant with:
EN61131-2 Programmable Controllers
C-Tick
Australian Radiocommunications Act, compliant with:
AS/NZS 2064 Industrial Emissions
(1) The combination of all output power (5V backplane, 24V backplane, and 24V user source) cannot exceed 70 W.
(2) Power supply fuse is intended to guard against fire hazard due to short-circuit conditions. This fuse may not protect the
supply from miswiring or excessive transient in the power line.
(3) Fuse sizes specified are for end-devices only. Fuse size may need to be reduced depending on the size of circuit wiring.
(4) Equivalent fuses: 250V-3A fuse, nagasawa ULCS-61ML-3, or BUSSMAN AGC 3.
(5) Equivalent fuse: 250V-3A fuse, SANO SOC SD4, or BUSSMAN AGC 3.
(6) Equivalent fuse: 125V-5A fuse, LITTLEFUSE 233.
(7) Use time-delay type overcurrent protection in all ungrounded conductors.
(8) Isolation is between input terminals and backplane.
(9) CPU hold-up time is for 0V unless specified. Hold-up time is dependent on power supply loading.
(10) See the Product Certification link at http://ab.com for Declarations of Conformity, Certificates, and other certification
details.
Attribute Value
1746-P1 1746-P2 1746-P3 1746-P4