Rockwell Automation 1784-KTCX15 INSTL INSTR CONTROLNET COMM. User Manual
Page 15
ControlNet Communication Interface Card
15
Publication 1784-5.33 – September 1997
Figure 2
Series B Jumper Explanations
E1
E2
E1
E2
Use these jumper positions for:
– normal card operation
– field flash upgrade of the card’s main code
Use these jumper positions for field flash upgrade of the
card’s boot code.
IMPORTANT: All other E1 and E2 jumper combinations are illegal.
Unknown card operation will result.
E3
When installed, use this jumper to latch certain address lines
that some 286 and older machines may not latch.
If you have this computer:
then:
286-based or older
you may need to install this jumper
386-based or newer
these address lines are usually latched
in the computer and, thus, the jumper is
not usually required
22
ControlNet Communication Interface Card
Publication 1784-5.33 – September 1997
5. Press any key.
You see a window similar to this one:
MSDOS a:\KTCINSTNT.EXE
Success... Hard resetting card
Success... Starting cards processor
Success... Attempting to locate DualPort address...
Found at 0Xd0000
Success... Searching for version mailbox
bootcode version: 2.1 3/17/97
Serial#: 2222 <8AE>
Main Code Version 99.60 4/29/97
Success... Testing Mail Boxes
Waiting... Soft Resetting the KTCX15 as network
address ID8. Press any key.
6. Press any key. You see a similar message:
Waiting... Setting KTCX to online. Press any key.
7. Press any key.
You see a similar message:
Success... Setting KTCX to online. KTCX LEDs should show flashing red.
Waiting... Setting KTCX to offline. Press any key.
Flashing red LEDs indicate that the card can communicate on a network, if
it’s connected to a network.
8. Press any key.
You see a similar message:
Success... Setting KTCX to offline. KTCX LEDs should show flashing green.
Waiting... Resetting KTCX. Press any key.
Alternate green and red LEDs indicate that your card reset successfully.
If this test fails, make certain that you are not connected to a network.
Contact your local Rockwell Automation sales representative or distributor,
or Rockwell Automation Technical Support at (440) 646-6800.