Rockwell Automation 1784-KTCX15 INSTL INSTR CONTROLNET COMM. - Manual (Page 17)

ControlNet Communication Interface Card 17
Publication 1784-5.33 – September 1997
Inserting the Card
To insert the card inside the computer:
1. Follow the card handling instructions on page 4.
2. Make sure you have correctly set all of the switches on the card.
3. Insert the card into the edge connector and tighten the expansion slot screw.
4. Turn on the computer to make sure it comes up correctly.
If the computer: then:
powers up go to step 5
hangs up you probably have a memory or I/O conflict
You should
• change switch settings and cycle power, or
• remove all other cards and try again
If you are still unsuccessful, contact your local
Rockwell Automation sales representative or
distributor, or Rockwell Automation Technical
Support at (440) 646-6800.
5. Replace the CPU cover (when computer comes up correctly).
20 ControlNet Communication Interface Card
Publication 1784-5.33 – September 1997
7. Press any key.
You see:
Succeeded Setting KTCX to online. KTCX LEDs should show flashing red.
Flashing red LEDs indicate that the card can communicate on a network, if
it’s connected to a network.
If this test fails, contact your local Rockwell Automation sales representative
or distributor, or Rockwell Automation Technical Support at (440) 646-6800.
Waiting.. Setting KTCX to offline. Press any key.
The utility takes the card off of the network.
8. Press any key
You see:
Succeeded Setting KTCX to offline. KTCX LEDs should show flashing green.
Flashing green LEDs indicate that the card successfully made the transition
from online to offline, i.e., from simulating network communication to
operating independently.
If this test fails, contact your local Rockwell Automation sales representative
or distributor, or Rockwell Automation Technical Support at (440) 646-6800.
Waiting.. Resetting KTCX. Press any key.
The utility re-initializes the card.
9. Press any key.
You see:
Succeeded Resetting KTCX. KTCX LEDs should alternate green and red.
Test of KTCX’s basic functionality succeeded. Installation successful.
Alternate green and red LEDs indicate that your card reset successfully.
If this test fails, contact your local Rockwell Automation sales representative
or distributor, or Rockwell Automation Technical Support at (440) 646-6800.