Rockwell Automation 1769-OB32T Compact 32-point Solid-state 24V dc Source Output Module - Manual (Page 15)

Compact 32-point Solid-state 24V dc Source Output Module 15
Publication 1769-IN080A-EN-P - August 2006
The 1492 interface module stick-on labels are abbreviated as follows: +V1 = V dc 1,
+V2 = V dc 2, CM1 = Com 1, and so on.
If the 1769-OB32T stick-on label set is not available, use the 1492 interface module
stick-on label set for 1746-OB32 modules.
Assemble the Wire Contacts
1. Strip the wire insulation (1).
Refer to the graphic under Step 4. Crimp pins can accept 0.13….33 mm
2
(26…22 AWG) wire.
2. Insert the wire up to the wire stop (2).
3. Crimp with DDK crimp tool 357J-5538.
Equivalent Amp part numbers are: pin - #87666-2, connector - #102387-9,
and crimp tool - #90418-1.
If a crimp tool is not available, use the following crimping procedure:
a. Crimp the wire barrel around the wire using small needle-nose pliers.
b. Crimp the insulation barrel around the wire insulation using small
needle-nose pliers.
c. Solder wire and wire barrel together using rosin core
(60% tin/40% lead) solder and soldering pencil.
TIP
If you decide to build your cable using another 1746-N3 to terminate the
cable at the 1492 interface-module end, wire it in the following manner:
Pin 1 to Pin 1, Pin 2 to Pin 2, Pin 3 to Pin 3, and so on.
TIP
Pins and connectors from different manufacturers cannot be
assembled together. For example, Amp pins cannot be used with a
DDK connector.