Rockwell Automation 1769-OB32T Compact 32-point Solid-state 24V dc Source Output Module - Manual (Page 6)

6 Compact 32-point Solid-state 24V dc Source Output Module
Publication 1769-IN080A-EN-P - August 2006
Spare/Replacement Module Parts
You can order the 1746-N3 connector kit, which contains one connector and 40
terminals.
Install the 1769-OB32T Module
Attach the module to the controller or an adjacent I/O module before or after
mounting.
For mounting instructions, see Mount Module to Panel Using the Dimensional
Template on page 9, or Mount Module to DIN Rail on page 10.
Refer to Replace a Single Module Within a System on page 7 to work with a system
that is already mounted.
The following procedure shows you how to assemble the Compact I/O system.
1. Disconnect power.
2. Check that the bus lever of the module to be installed is in the unlocked
(fully-right) position.
3. Use the upper and lower tongue-and-groove slots (1) to secure the modules
together (or to a controller).
4. Move the module back along the tongue-and-groove slots until the bus
connectors (2) line up with each other.
1
1 2
6
5
4
3
30536-M