Rockwell Automation 1792D-KPLT ArmorBlock MaXum Cable Base - Manual (Page 2)

2 ArmorBlock MaXum Robot I/O Cable Base and Kempf Box Plate
Publication 1792D-IN054B-EN-P - April 2003
These instructions describe the installation of the cable base. The
catalog numbers for the cable base and Kempf box are:
•
1792D-CB23 (for 23mm trunk or drop cable installation)
•
1792D-KPLT (to mount the cable base on a Kempf box)
Important User Information
Because of the variety of uses for the products described in this
publication, those responsible for the application and use of these
products must satisfy themselves that all necessary steps have been
taken to assure that each application and use meets all performance
and safety requirements, including any applicable laws, regulations,
codes and standards. In no event will Rockwell Automation be
responsible or liable for indirect or consequential damage resulting
from the use or application of these products.
Any illustrations, charts, sample programs, and layout examples
shown in this publication are intended solely for purposes of
example. Since there are many variables and requirements associated
with any particular installation, Rockwell Automation does not
assume responsibility or liability (to include intellectual property
liability) for actual use based upon the examples shown in this
publication.
Allen-Bradley publication SGI-1.1, Safety Guidelines for the
Application, Installation and Maintenance of Solid-State Control
(available from your local Rockwell Automation office), describes
some important differences between solid-state equipment and
electromechanical devices that should be taken into consideration
when applying products such as those described in this publication.
Reproduction of the contents of this copyrighted publication, in
whole or part, without written permission of Rockwell Automation, is
prohibited.
IMPORTANT
ArmorBlock MaXum modules and media cables
are ordered and shipped separately.