Rockwell Automation 1792D-KPLT ArmorBlock MaXum Cable Base - Manual (Page 7)

ArmorBlock MaXum Robot I/O Cable Base and Kempf Box Plate 7
Publication 1792D-IN054B-EN-P - April 2003
Attach the Module to the Base
1. Position the module over the mounted cable base. Align the
three captive screws in the module with the accepting
receptacles in the base.
2. Tighten the screws with a torque of 8 inch-pounds to secure
the module to the base.
IMPORTANT
Make sure you properly align the screws to
complete the connections between the module
contacts and the cable contacts.
!
WARNING
If you insert or remove the module while
backplane power is on, an electrical arc can
occur. This could cause an explosion in
hazardous location installations.
Be sure that power is removed or the area is
nonhazardous before proceeding.
43335
Screws must be
aligned properly to
complete contact
connections.
Contact
connections