Rockwell Automation 1791P-XXXX CompactBlock Distributed I/O on PROFIBUS DP Series D I.I. - Manual (Page 16)

16 CompactBlock Distributed I/O on PROFIBUS DP Series D
Publication 1791P-IN002B-EN-P - October 2003
2. Lift the terminal block out of the base.
Insert the Terminal Block
To insert the CompactBlock terminal block:
1. Insert the terminal block by aligning it and pushing it back until it
rests against the back of the module.
2. Tighten the retaining screws on each side of the terminal block until
the terminal block is firmly in place.
Communicate With the 1791P Module
Determine the Baud Rate for Your PROFIBUS Connection
All 1791P CompactBlock PROFIBUS I/O modules contain the autobaud
feature. Autobaud lets the modules automatically detect the baud rate for the
network upon connection to the live network.
VDC
VDC
GND
GND
Not
Used
IN0
IN2
IN4
IN6
IN7
IN5
IN3
IN1
IN8
IN10
IN12
IN14
IN15
IN13
IN11
IN9
Retaining Screw
Retaining Screw
43111