Rockwell Automation 1794-ID2/B INSTALL INSTR 24v FLEX I/O 2 CHANNEL Incremental Encoder Module - Manual (Page 7)

FLEX I/O 2-Channel Incremental Encoder Module 7
Publication 1794-IN063C-EN-E - February 2014
Install the Module
Read this for information about how to install the module, which mounts on a 1794-TB3
or 1794-TB3S terminal base.
To install the module on a 1794 terminal base, refer to the figure and complete the
following.
1. Rotate the keyswitch (2) on the terminal base (3) clockwise to position 3 as
required for this type of module.
2. Make sure the flexbus connector (7) is pushed all the way to the left to connect
with the neighboring terminal base or adapter.
Module Description
Description Description
1 Latching mechanism 5 Alignment bar
2 Keyswitch 6 Module
3 Terminal base 7 FlexBus connector
4 Groove
ATTENTION: During mounting of all devices, be sure that all debris (such as
metal chips or wire strands) is kept from falling into the module. Debris that
falls into the module could cause damage on powerup.
ATTENTION: You cannot install the module unless the connector is fully
extended.
44341
3
4
7
1
2
6
5