Rockwell Automation 1792-IB2XOB2E/B INSTL.INST ARMOR BLOCK 2 INPUT - Manual (Page 14)

ArmorBlock 2 Input/2 Output Module 14
Publication 1792-5.5 – October 1996
Configuring the Parameters
Default settings for the 2 in/2 out module are:
autobaud when enabled, matches device baud rate to network baud
rate at powerup enable
off to on delay time from a valid input signal to recognition by the block
module no delay
on to off delay time from input signal dropping below the valid level to
recognition by the block module no delay
fault state defines output behavior during a communication fault reset outputs
idle state defines output behavior during program mode reset outputs
reset faulted I/O reset sensor source voltage and faulted outputs nothing selected
1. Double click on the parameter you want to change.
The parameter screen appears.