Rockwell Automation Logix5000 Controllers Produced and Consumed Tags Programming Manual - Manual (Page 21)

Produce and Consume a Tag Chapter 1
The Consuming controller must be set up to allow its consumed tags to accept an
RPI provided by the producer. Follow these steps to access the Controller
Properties dialog box.
1. In the Controller Organizer, right-click a controller that has been set up
with a consuming tag and choose Properties.
The Controller Properties dialog box appears with the General tab as the
default.
2. Click the Advanced tab.
3. Check Allow Consumed Tags to Use RPI Provided by Producer.
4. Click OK.
Set up the consumer tag
Rockwell Automation Publication 1756-PM011F-EN-P - October 2014 21