Rockwell Automation 1790P-T8BV8B Profibus DP Digital Base Terminal Block Compact Block LDX I/O I.I. - Manual (Page 11)

11
Publication 1790-IN009B-EN-P - April 2003
Once you have properly wired the connector, attach it to the
base block as shown below. Use the locking screws on the
connector to fasten it to the base block.
Connect Power to the Block
To apply power to the block, refer to the above illustration.
Module
Power Connector
(underneath module)
PROFIBUS
Connector
Green - GND
Black - COM
Red - +24Vdc