Mount the base block – Rockwell Automation 1790P-T8BV8B Profibus DP Digital Base Terminal Block Compact Block LDX I/O I.I. User Manual
Page 6
6
Publication 1790-IN009B-EN-P - April 2003
Mount the Base Block
You can mount the base block to a panel or DIN rail. We
recommend that you ground the panel or DIN rail before
mounting the base block.
Panel Mounting
1. Place the base block against the panel where you want
to mount it.
2. Gently pull and position the expansion cover to the left.
3. Place a center punch, nail or similar device through the
mounting holes in the base block and make two marks
on the panel (lower left and upper right corners of the
base block).
4. Remove the base block and drill two holes in the panel
to accommodate each of the mounting screws.
When used in a Class I, Division 2, hazardous
location, this equipment must be mounted in a
suitable enclosure with the proper wiring
method that complies with the governing
electrical codes.
WARNING
!