Insert the module, Wire the module – Rockwell Automation 1746-NR4 SLC RTD/Resistance Input Module User Manual User Manual
Page 25
Publication 1746-UM008B-EN-P - December 2006
Quick Start Guide 25
Insert the Module
Make sure system power is off; then insert the RTD module into your
1746 chassis. In this example procedure, local slot 1 is selected.
Module Insertion into Chassis
Wire the Module
Connect RTD module or potentiometer wire leads to channel 0 of the
RTD module.
See RTD Connections to Terminal Block on page 26, Two-wire
Potentiometer Connections to Terminal Block on page 27, or
Three-wire Potentiometer Connections to Terminal Block on page 28.
For more information refer to chapter 3, Install and Wire.
ATTENTION
Never install, remove, or wire modules with power applied to
the chassis or devices wired to the module.
For more information refer to chapter 3, Install and Wire.
Card Guide
Top and Bottom
Module Release(s)