Install the module, Remove the module – Rockwell Automation 1746-NR4 SLC RTD/Resistance Input Module User Manual User Manual
Page 39
Advertising
Publication 1746-UM008B-EN-P - December 2006
Install and Wire the Module 39
Install the Module
1. Align the circuit board of the RTD module with the card guides
located at the top and bottom of the chassis.
2. Slide the module into the chassis until both top and bottom
retaining clips are secured. Apply firm even pressure on the
module to attach it to its backplane connector. Never force the
module into the slot.
3. Cover all unused slots with the Card Slot Filler, catalog number
1746-N2.
Remove the Module
1. Press the releases at the top and bottom of the module and slide
the module out of the chassis slot.
2. Cover all unused slots with the Card Slot Filler, Catalog Number
1746-N2.
Top and Bottom
Module Release(s)
Card
Guide
Advertising