Rockwell Automation 1769-IQ32T Compact Module - Manual (Page 6)

6 Compact 32-point 24V dc Sink/Source Input Module
Publication 1769-IN072A-EN-P - June 2005
7. Attach an end cap terminator (5) to the last module in the system by using the
tongue-and-groove slots as before.
8. Lock the end cap bus terminator (6).
Mounting Expansion I/O
Minimum Spacing
Maintain spacing from
enclosure walls, wireways,
adjacent equipment, etc.
Allow 50 mm (2 in.) of space
on all sides for adequate
ventilation, as shown:
Panel Mounting
Mount the module to a panel using two screws per module. Use M4 or #8 panhead screws.
Mounting screws are required on every module.
IMPORTANT
A 1769-ECR or 1769-ECL right or left end cap must be used to terminate
the end of the serial communication bus.
ATTENTION
During panel or DIN rail mounting of all devices, be sure that all debris
(metal chips, wire strands, etc.) is kept from falling into the module.
Debris that falls into the module could cause damage on power up.
Controller
Compact I/O Compact I/O Compact I/O Compact I/O Compact I/O
End Cap
Top
Bottom
Side Side