Register the driver in rslinx software – Rockwell Automation 1788-EN2DN Ethernet-to-DeviceNet Linking Device User Manual
Page 18
18 Ethernet-to-DeviceNet Linking Device
Rockwell Automation Publication 1788-IN055C-EN-P - September 2011
6.
Enter the following values into the IP Configuration dialog box.
7.
Click Submit Values.
8.
Follow the on-dialog box prompts.
9.
Click the Reset Module button to reset the linking device.
Register the Driver in RSLinx Software
1.
In RSLinx software, choose Communications>Configure Driver.
2.
In the Configure Drivers menu, choose Ethernet Devices from the
Available Driver Types pull-down menu.
3.
Click Add New.
4.
In the Add New RSLinx Drivers pop-up menu, click OK.
5.
In the Configure Driver window that appears, enter the IP address of the
linking device.
6.
Click Close.
7.
Click OK.
In this field
Enter
IP Address
Any valid value. See your system administrator for a
valid IP address.
Subnet Mask
Any valid value.
Gateway IP Address
DHCP enabled