Rockwell Automation 1756-LSP GuardLogix Controller - Manual (Page 6)

6 GuardLogix Controllers
Publication 1756-IN045E-EN-P - October 2009
Install a CompactFlash Card
1. Turn the keyswitch to the PROG position.
2. Open the door of the controller.
3. Push the CompactFlash latch to the left.
4. Insert the CompactFlash card with the A-B logo pointing left.
5. Release the latch and make sure it slides over the CompactFlash card.
WARNING
When you insert or remove the CompactFlash card an electrical arc can occur.
This could cause an explosion in hazardous location installations. Be sure that
power is removed or the area is nonhazardous before proceeding.
ATTENTION If you are not sure of the contents of the CompactFlash card, before you install
the card, turn the keyswitch of the controller to the PROG position. Depending
on the contents of the card, a power cycle or fault could cause the card to load
a different project or operating system into the controller.
RS232
BATTERY PORT
1-DCD
2-RXD
4-DTR
3-TXD
5-GND
DSR-6
CTS-8 RTS-7
N/C-9
1
2
BATTERY DATE
UP
COMPACT FLASH
2
To
Insert 1
To Eject
1 + 2 2
1
1