Rockwell Automation 1746-BAS-T SLC 500 Basic Basic-T Modules - Manual (Page 35)

1 Publication 1746-UM004B-EN-P - December 2005
Chapter
3
Install and Wire Your Module
After reading this chapter, you should:
• set the module’s jumpers.
• install your module into your SLC 500 fixed or modular
controller system.
• wire the mating connectors of the cables used to interface user
devices to the module ports.
Set Module Jumpers The module has four sets of jumpers that you need to set. Jumpers
JW1 and JW2 configure ports PRT1 and PRT2. Jumper JW3 configures
the type of optional memory module. Jumper JW4 configures the
program port. The following figure shows the location of these
jumpers.
Figure 3.1 Jumper Locations
SLC 500 BASIC MODULE
CA
T
SER
SERIAL
NO.
FRN
1
2
3
4
5
6
7
8
9
CONFIG
1
2
3
4
5
6
7
8
9
DF1
DH485
JW3
JW4
JW1
JW2
Memory Module
Battery