Rockwell Automation 1746-BAS-T SLC 500 Basic Basic-T Modules - Manual (Page 41)

Publication 1746-UM004B-EN-P - December 2005
Install and Wire Your Module 3-7
The BASIC module or BASIC-T module can also be installed in an SLC
fixed controller expansion chassis.
1. Turn off power to the chassis where you will insert the module.
2. Align the circuit board of the module with the card guide of a
slot (except slot 0) in the 1746 chassis.
Figure 3.6 Module Location in the Chassis
3. Slide the module in until the top and bottom retainer clips are
secured.
ATTENTION
Never install, remove, or wire any module while
power is applied. Also, do not expose the modules
to surfaces or other areas that may typically hold an
electrostatic discharge.
Electrostatic discharge can damage integrated circuits
or semiconductors if you touch backplane connector
pins.
If the equipment is not installed and used as
described in the SLC 500 Modular Hardware Style
User Manual, publication 1747-UM011, the protection
provided by the equipment may be impaired.
Card Guide
Module Release