Rockwell Automation 1746-BAS-T SLC 500 Basic Basic-T Modules - Manual (Page 57)

Publication 1746-UM004B-EN-P - December 2005
Programming Overview 4-9
2. Connect the ASCII terminal to the selected program port on the
module.
3. Verify that the console device is configured to communicate with
the module (protocol and communication settings).
4. Apply power to your system.
If there is no program in RAM, this appears on the ASCII terminal.
If there is a program in RAM and the module has been programmed to
execute from RAM, this program starts running. If you type
[Ctrl-C]
this screen appears:
SLC 500 BASIC Module - Catalog Number 1746-BAS
Firmware release: 1.00
Allen-Bradley Company, Copyright 1991
All rights reserved
.
.
.
STOP - IN LINE XXX
IMPORTANT
The system prompt
[>]
indicates that the module is
in Command mode, and the module ACT indicator
light should be blinking.