Rockwell Automation 1756-EWEB ControlLogix EtherNet/IP Web Server Module Installation Instructions - Manual (Page 14)

14 EtherNet/IP Web Server Module
Publication 1756-IN588A-EN-P - February 2004
Connect the Module to the EtherNet/IP Network
Attach the RJ45 connector to the EtherNet/IP port on the bottom of the
module as shown below:
WARNING
If you connect or disconnect the communications
cable with power applied to this module or any device
on the network, an electrical arc can occur. This could
cause an explosion in hazardous location installations.
This is the bottom, back of the module that
connects into the chassis.
RJ-45 EtherNet/IP
connector
Connect the cable
here.