Select the operating mode of the controller, Select the operating mode of the controller se – Rockwell Automation 1794-FLA FlexLogix Controller Installation Instructions User Manual
Page 21
FlexLogix Controller System 21
Publication 1794-IN002G-EN-P - January 2004
Select the Operating Mode of the Controller
1. Use this table to determine the operating mode of the controller:
2. Turn the key on the front panel of the controller to select the mode.
If you want to:
Select one of these modes:
Run
Program
Remote
Run
Program
Test
turn outputs to the state commanded by
the logic of the project
YES
YES
turn outputs to their configured state for
Program mode
YES
YES
YES
execute (scan) tasks
YES
YES
YES
change the mode of the controller
through software
YES
YES
YES
download a project
YES
YES
schedule a ControlNet network
YES
YES
while online, edit the project
YES
YES
YES
YES
To select:
Turn the key to:
Remote Run
RUN and then to REM
Remote Program
PROG and then to REM
Remote Test
REM and then go online and select Test mode via the programming software
keyswitch