Rockwell Automation 1734-AENT Point I/O Ethernet Adapter Installation Instructions - Manual (Page 7)

POINT I/O EtherNet/IP Adapter 7
Publication 1734-IN590B-EN-P - February 2005
For More Information
The following related publications are available online at URL
http://literature.rockwellautomation.com.
Install the EtherNet/IP Adapter
To install the adapter on the DIN rail prior to installing other base
units, proceed as follows.
1. Position the adapter vertically above the DIN rail.
2. Press down firmly to install the adapter on the DIN rail. The
locking mechanism will lock the adapter to the DIN rail.
3. Set the node address on the node address thumbwheel.
Publication Title Publication Number
POINT I/O EtherNet/IP User Manual 1734-UM011
POINT I/O EtherNet/IP Adapter Release Notes 1734-RN002
WARNING
If you connect or disconnect the Ethernet cable
with power applied to this module or any device on
the network, an electrical arc can occur. This could
cause an explosion in hazardous location
installations.
Be sure that power is removed or the area is
nonhazardous before proceeding.